AES 7170 Bedienungsanleitung PDF herunterladen (Seite 105)

40-7705I-UM Page 105 Rev 4 March 16, 2007

Fault and Status Codes (Zone information): AES Subscribers and MultiNet Receiver (not all are used by each device):

800 = No Faults, Unit OK or Restoral of all Prior Faults.

801 = Low Battery - Voltage less than 11.0V

802 = RAM Data error or RAM corrupted - Zone activation will not be reported (Sub. V1.71 &+). Reprogram Unit

803 = 7050 and 7000/2 - U11 RAM Chip Internal Battery Bad

7050E - EEPROM corrupted, or not present

804 = 7050E - A to D Converter Faulted - Zone activation will not be reported (Sub. V1.71 &+).

804 = External Device failed

805 = Modem Chip Failed or missing - U9 in 7050 and 7000/2

806 = Timing Error between CPU and Modem

807 = Ram Chip Read/Write test Failure - U11 in 7050 and 7000/2

808 = Modem Loop back Failed - U9 in 7050 and 7000/2

809 = 7050E - AC Fail or DC voltage supplied by AC has dropped below 12V

Line Card # 3 Contact ID received through IntelliTap.

Signal format: <LF>RLsACCTs18sEEEEsGGsNNNNs<CR>

See “Line card #1”, “Signal format” in “ Ademco 685 compatible output” for Key to codes used in signal format for Line Card #3 above.

This Information is passed through. Receiver number is set as programmed in the MultiNet setup. Line card is set to 3.

Line Card # 4 4+2 received through IntelliTap.

Signal format: <LF>RLsACCTsCC<CR>

CC = two digit zone code.

See “Line card #1”, “Signal format” in “ Ademco 685 compatible output” for Key to codes used in signal format for Line Card #4 above.

This Information is passed through. Receiver number is set as programmed in the MultiNet setup. Line card is set to 4.

Input Signals:

In Ademco mode the receiver will respond to 3 inputs or signals from the monitoring system.

S receiver reply will be - <LF>00sOKAYs@<CR>

<0x06> or ASCII code 6 receiver considers last message acknowledged

<0x15> or ASCII code 21 receiver will re-send last message (if not acknowledged)

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 111

Keine Kommentare

AES 7170 Bedienungsanleitung Seite 105