AES 7170 Bedienungsanleitung PDF herunterladen (Seite 15)

40-7705I-UM Page 15 Rev 4 March 16, 2007

Notes:

• Power Line, router/ switch, and telephone connections shall not leave the

room where the AES equipment is installed. This must be accomplished

by co-locating outlets and interfacing equipment in the room where AES

equipment resides.

• 7705i must be installed in a UL Listed metal rack-mounting cabinet that

complies with UL864. The cabinet must be provided with integral outlets

and the ability to connect AC input via conduit. All wiring exiting the

cabinet must be in electrical conduit. Be sure non-power limited and

power limited wiring are separated by at least 1/4 inch.

• All equipment shall be connected to a UL Listed UPS (UL 864) or UL

1481 power supply. In addition, the central station shall have a generator

to maintain power for the receiving equipment and environmental

controls for a period up to 24 hours or longer.

• A UL Listed UPS or generator to supply 24 hours of standby must be

installed and utilized at the monitoring station. If the primary power

source at the monitoring station is lost or otherwise faulted, this condition

must be obvious to the operator on duty.

• Equipment Location: A UL 7705i MultiNet Receiver must be

installed in a room where operators can properly hear the Audio Alert

Sounder.

• When connecting the 7705i MultiNet Receiver’s modem to a telephone

line, a UL Listed 497A Secondary Protector is required to be installed on

the incoming lines. Installation shall be in accordance with the NEC

Article 800, the manufactures installation instructions and in accordance

with all local codes.

• When connecting the 7705i MultiNet Receiver’s Ethernet ports to a

network, a UL Listed 497B Secondary Protector is required to be

installed on the Ethernet cable. Installation shall be in accordance with

the NEC Article 800, the manufactures installation instructions and in

accordance with all local codes.

4.1 Software Installation:

All necessary software is pre-installed on your 7705i.

If your system has a catastrophic failure it may require the reinstallation of the

Linux operating system and the specialized IP-Link software programs. BIOS

settings should also be checked to confirm that the unit would initialize and

operate properly. Routine backing up of the databases to another storage device

would be essential in any successful reinstallation or recovery process.

Contact AES Technical Support if you need assistance with software installation

or BIOS settings.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 110 111

Keine Kommentare

AES 7170 Bedienungsanleitung Seite 15