AES 7170 Bedienungsanleitung PDF herunterladen (Seite 34)

40-7705I-UM Page 34 Rev 4 March 16, 2007

• Verbose: Controls the amount of information written to limited size

log files. A pull down menu allows you to set this parameter to Off, On or

Full. In most cases, the Off setting should be used, so that only critical

messages are written to the log files. If more information about system

operation is required, the On setting can be used. The Full setting should

only be used at the direction of AES support personnel. This is an

“Event” log. The more information stored on each event reduces the total

number of events stored in the log.

• Set Configuration: When complete, Click the [Set Configuration] button

to save the configuration. If you have not already created at least one

Business Unit, you will be asked to do so before leaving the Server

Configuration screen.

6.2 Define Business Units: (you must have at least one)

Each subscriber unit’s application data type must be associated with a

Business Unit. Business Units are defined based on the types of

application data they process. Each Subscriber must be associated with

the proper type Business Unit to handle the data packets produced by the

Subscribers. Since every Subscriber creates at the very least, Check-In,

Status and other routine messages, most Business Units have settings for

Alarm data and may have to be linked with the Business unit of Data

Type: Security, if those messages are to be monitored by an alarm

monitoring system. Each user that will have remote access would have a

Business Unit set up for their exclusive use.

To provide for site-specific particulars, there are no user Business Units

pre-configured in the MultiNet receiver from the factory. You need to

create at least one to continue.

Select “Add” under “Business Units” in the left side of the window.

Figure 6-4 Add Business Unit Screen

If this is your

First Business

Unit, select this?

You can change it

later if necessary.

Do not select this

checkbox if this is

an additional

Business Unit tha

will use the Serial

Port already

configured for use

by another

Business Unit.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 110 111

Keine Kommentare

AES 7170 Bedienungsanleitung Seite 34